12 buttons / 2 step – Industrial Radio Operated Control

12 button transmitter with 2 step buttons

12 buttons, where 8 buttons are two step and four buttons where the second step is activated after a configurable time
active stop function
listen before talk (LBT) or fixed radio frequency
using bank mode, it it possible to control up to 44 different functions
highly configurable

possible to configure a pin code, to prevent unauthorized use of the transmitter.
“auto OFF” function which automatically presses the stop button after configured time (up to 60 minutes). Possible to disable.
the four single step buttons simulate “two step” button. The second function is sent when the button has been pressed for a pre-defined time. This time can be set from 0.1 s to 9.9 s in steps of 0.1 s.

Bank mode: 1 to 4 buttons can be configured to select 1 out of 4 different “banks”. Depending on which bank is selected, the buttons can be freely configured to control any relay in the receiver.
One TX12CS can be paired with multiple receivers, and it is possible to configure any button to control any relay in any of the paired receivers.
In LBT mode (listen before talk), the TX12CS will automatically find an unused frequency before starting to transmit.

stop button that meets performance level d (PLd)
every time when the operator starts the transmitter, it will make an automatic self test. If the self test fails, the transmitter will not start.
after transmitter is started, it will send a continuous signal to the receiver.
if the transmitter is out of range, the stop function of the receiver will immediately stop the system.
if the operator presses the stop button, the receiver will immediately stop the system.
the stop button has two parallell fail-safe systems to detect when the button is pressed.
every time the stop button is pressed, a self test is performed of the stop button.
if there is a failure in one of the stop button systems, the stop button will still work, but it will not be possible to start the transmitter again.

rechargeable battery allowing for up to 50 hours of continuous use (depending of configuration)
possible to operate the transmitter and charge at the same time, if extremely long operation time is needed
small, lightweight and robust
all control logic is placed in the receiver, which means that it is very easy to configure a TX12CS. In most cases, it is enough to “pair” the TX12CS with the RX08.
long range operation, can be used at up to 500 meters
operates at the 434 MHz band
can operate on 69 different channels
water and dust resistant
CE approved