Receiver with 8, 17 or 25 relays and 2 stop relays
Functionality
- wifi interface with built-in web page for easy configuration.
- the wifi interface makes it possible to remove or add allowed transmitters.
- with the wifi interface, the RX08 can be configured without the need to open the lid or even being close to the RX08
- the wifi interface has a built-in spectrum analyzer to help analyzing the occupancy of radio frequencies.
- built in documentation system. When the system is fully configured, the web page can generate a printable PDF with the current setup.
- built in backup and restore functionality. The current configuration can be saved to your laptop, and used as a template when configuring new receivers or replacing a broken RX08.
- almost all settings are stored in the RX08, which means that it is very simple to add or replace a transmitter. A new transmitter only needs a minimal configuration before it can be used.
Configuration options (when ordering)
- a button press on the receiver can activate any relay or even more than one relay.
- every button on the transmitter can be configured in four different modes: normal, latching, always on and always off.
- always ON/OFF means it is possible to configure that one button should always start eg. start a pump and other button should always stop the same pump.
- it is possible to configure “priority” between buttons, which means that if one button is active, the RX08 will ignore any press of the other button.
- bank mode: depending which bank that is selected in the transmitter, a different set of configuration will be used by the RX08. Up to 4 different banks can be configured.
- one TX12CS can, at the same time, control any number of RX08’s, it just needs to be “paired” with all RX08’s. In this setup, every RX08 could have a separate configuration. This makes it possible for one RX08 to only act on some functions, and next RX08 can act on a different set of functions, etc.
- there is a specific configuration in the TX12CS and the RX08. In this mode, it is possible to have four RX08 that simultaneously works together. From the TX12CS, it is possible to select which (or all) of the RX08 that should be active.
- LBT mode (listen before talk), or set to a fixed frequency.
Safety functions of RX08
- stop function that meets performance level d (PLd)
- two high quality safety relays, which are actively monitored for failures
- the two safety relays are activated when a valid transmitter starts transmitting
- if the stop button is pressed on the transmitter, the stop function is immediately activated
- if the transmitter is out of range, the stop function is immediately activated
- the RX08 is locked to one specific transmitter (“manual logoff” mode). If another transmitter should be able to control the RX08, the operator of the active transmitter must “logoff” the RX08 by pressing a specific button after the stop button is pressed.
- possible to disable “manual logoff”, the RX08 will then automatically logoff the transmitter when stop is pressed
Highlights – RX08
- easy and intuitive to setup and configure
- extremely flexible configuration of relays which means that the standard version it is suitable for many different applications
- long range operation, can be used at up to 500 meters
- operates at the 434 MHz band
- can operate on 69 different channels
- water and dust resistant
- power supply 9 – 40 VDC / 40 – 230 VAC
- size: 120 x 220 x 65 mm, 250 g
- CE approved